Auto-zone-control-systems CommLink 5 Technical Guide, Installation Instructi Manuel d'utilisateur télécharger pdf (Page 12)

CommLink 5 Technical Guide

Operator Interface

CommLink 5 LED Descriptions

Figure 3: CommLink 5 LED Display

CommLink 5 LED Descriptions

USB LEDs

LOOP - Indicates communication activity on local controller

network. This LED ﬂ ickers when data is exchanged with the

controller network.

TX-USB - Indicates transmitted data status of USB connection.

This LED only ﬂ ashes when your CommLink 5 is connected

to a computer and data is sent to Prism from the CommLink 5

via USB.

RX-USB - Indicates received data status of USB connection.

This LED only ﬂ ashes when your CommLink 5 is connected

to a computer and data is sent from Prism to the CommLink 5

via USB.

COMP- Indicates connection to your computer. This LED will

turn on solid once you plug the USB cable into your computer

as long as the connection is not lost.

NETWORK LEDs

ACT-LAN - Indicates activity on the local area network. This

LED ﬂ ashes on when LAN is transmitting and receiving data

and is only operational with an Ethernet connection.

LNK-LAN - Indicates local area network is connected. This

LED is on when connected to LAN and is only operational

with an Ethernet connection.

WLAN - Indicates wireless connection to the local area network.

This LED ﬂ ashes on when LAN is transmitting and receiving

data and is only operational with an Ethernet connection.

1 2 ... 7 8 9 10 11 12 13 14 15 16

Pas de commentaire

Auto-zone-control-systems CommLink 5 Technical Guide, Installation Instructi Manuel d'utilisateur Page 12