Auto-zone-control-systems CommLink 5 Technical Guide, Installation Instructi Manuel d'utilisateur télécharger pdf (Page 11)

CommLink 5 Technical Guide

Operator Interface

Prism 2 Setup Instructions

12.  e Search for Installed Units Window will pop up.

Click <Start Search> located in the upper le -hand

corner of the window to initiate an automatic detection

of all installed controllers on your system.

13. If everything is working correctly, Units Found on this

Loop should load into the pull down window located on

the right.

14. If Units Found on this Loop stays at zero, check the wir-

ing to the CommLink 5 and the AHU/RTU Controllers

and/or read through these directions again to make sure

all steps were followed.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

Pas de commentaire

Auto-zone-control-systems CommLink 5 Technical Guide, Installation Instructi Manuel d'utilisateur Page 11